|
||
|
12th September 2009, 16:34 | #1 |
Newbie
MG ZT T Join Date: May 2009
Location: carlisle
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
|
zt diesel auto error codes
have a 54 zt-t diesel auto with 127000 miles on and recently had the engine management light come on got the codes read and it came up with 4 as follows:3505 glow time control, 1260 fuel pressure first stage check, 480 radiator fan control and 100 air flow meter. would like a little advice as to how serious these are and if they are needing looked at sooner rather than later, i have pierburgh air flow meter with a tu3 box fairly recently fitted would this have any bearing on these codes especially the last one
interestingly though the light is now off (it went off the day before i took it to get read) and has stayed off up until now(about a week),please help as i have got kind of attached to the old beast and wouldn't like to have to get it put down just yet |
12th September 2009, 17:43 | #2 |
Vis Whiz
Rover 75 2.5 auto Saloon Join Date: Jun 2007
Location: LEEDS
Posts: 20,591
Thanks: 2,057
Thanked 3,056 Times in 1,621 Posts
|
Hi there,
What did you use to get the codes? where abouts are you? If it was not a T4 machine the codes will be generic and may not relate correctly. If it was a T4, in the right hands should be self explanitory
__________________
Dave... Lost a few stones and a Gall Bladder and part of a bile duct and all of my dignity in the suppository incident |
19th September 2009, 20:19 | #3 |
Newbie
MG ZT T Join Date: May 2009
Location: carlisle
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
|
i'm not sure if it was a t4 ,as it's my brother in laws garage and is the machine he uses for general diagnostic work, by the way i'm near carlisle
|
|
|