|
||
|
22nd May 2008, 12:01 | #1 |
Regular poster
zt 160 Join Date: Mar 2008
Location: kenilworth, warks
Posts: 99
Thanks: 1
Thanked 1 Time in 1 Post
|
Iso Connector
Hi, i'm about to upgrade the Kenwood H.U on the ZT,the installation instructions state to check the pin wiring on the vehicle wiring ISO connector quote.Default setting .The A-7 pin (red) of the vehicle's ISO connector is linked with the ignition and the A-4 pin (yellow), is connected to the constant power supply.Can anyone confirm that this is the case?
T.I.A.
__________________
Reasons to be cheerful.-errr! |
22nd May 2008, 12:32 | #2 |
Regular poster
zt 160 Join Date: Mar 2008
Location: kenilworth, warks
Posts: 99
Thanks: 1
Thanked 1 Time in 1 Post
|
Many thanks for that, I'll check it out,don't want to do any damage by trying to be a S.A.
__________________
Reasons to be cheerful.-errr! |
22nd May 2008, 13:19 | #3 |
This is my second home
No longer in the MGR club Join Date: Nov 2006
Location: Tipperary
Posts: 3,933
Thanks: 35
Thanked 51 Times in 35 Posts
|
Sorry eeen, I deleted my post by accident , but here it is again.
My facelift is configured as you have stated but I don't think this is standard ISO wiring. Best to check with a multimeter or bulb. You will not do any damage by swapping these 2 wires around but you radio may not store the radio stations or you may not be able to switch on the radio without having the ignition on.
__________________
'Tis better to be silent and be thought a fool, than to speak and remove all doubt. |
|
|