|
||
|
21st September 2020, 15:19 | #21 |
Posted a thing or two
Rover 75 CDTi Saloon & Citroen C1 Join Date: Jun 2016
Location: Oakenshaw, Near Bradford
Posts: 1,622
Thanks: 385
Thanked 552 Times in 328 Posts
|
Well, my new steering column has arrived, in the largest box you could imagine. What were they thinking lol.
I will be taking photos of the change over, while following the info posted by Rich17865 some years ago.
__________________
Rover 75 2.0 CDTi (131Ps) Conn SE Saloon. (Manual) 160 Remap, cruise control, electric window blind, temp gauge, Real walnut / ZT interior, FBH with GSM control. BORN Tuesday, 5th October 2004 @ 12:35:52 This vehicle was the 104,679th 75 to run off the production line, out of 112,381 This vehicle was the 3,318th 75 CDT Connoisseur SE (135) to be made out of 4,744 This vehicle was the 12,440th 75 in Starlight Silver (code: MBB) to be made out of 14,280 Starlight Silver 75s |
24th September 2020, 19:25 | #22 |
Posted a thing or two
Rover 75 CDTi Saloon & Citroen C1 Join Date: Jun 2016
Location: Oakenshaw, Near Bradford
Posts: 1,622
Thanks: 385
Thanked 552 Times in 328 Posts
|
I fitted the new steering column this afternoon. Everything went to plan, and yes it does fit, well it fitted straight into my 2004 facelift anyway.
I used the white plastic pipe, silver gaffer tape and plenty of silicone spray to change the rubber gaiter over. A result! No more steering wheel wobble. Inspection of the column i removed shows the play is in a bearing at the lower end of the tube. I wouldn't have believed there could have been enough pressure on that bearing to wear it out in 120k miles. The only real explanation I can think of is that maybe its because that bearing sort of takes the strain of the slight bend in the column as it heads down to the connection with the steering rack.
__________________
Rover 75 2.0 CDTi (131Ps) Conn SE Saloon. (Manual) 160 Remap, cruise control, electric window blind, temp gauge, Real walnut / ZT interior, FBH with GSM control. BORN Tuesday, 5th October 2004 @ 12:35:52 This vehicle was the 104,679th 75 to run off the production line, out of 112,381 This vehicle was the 3,318th 75 CDT Connoisseur SE (135) to be made out of 4,744 This vehicle was the 12,440th 75 in Starlight Silver (code: MBB) to be made out of 14,280 Starlight Silver 75s |
25th September 2020, 10:42 | #23 | |
Posted a thing or two
Rover 75 Tourer CDT Auto. Join Date: Oct 2011
Location: Long Eaton
Posts: 1,342
Thanks: 30
Thanked 220 Times in 160 Posts
|
Quote:
I did say in Post 5 that the play in mine was at the bottom end of the column. I thought it was a bush. The strange thing was, mine started at 9 months old having covered about 5 thousand miles and only ONE month after Rover went belly up in 2005. It never really got any worse, and it wasn't until 2016 I swapped it purely in the hope it might stop the tickover vibration, which it did. I only tried it because I could buy such a cheap LHD one. |
|
25th September 2020, 21:33 | #24 |
Posted a thing or two
Rover 75 CDTi Saloon & Citroen C1 Join Date: Jun 2016
Location: Oakenshaw, Near Bradford
Posts: 1,622
Thanks: 385
Thanked 552 Times in 328 Posts
|
Yes, you were right, it was at the lower end. Jeez! I do hope it lasts longer than that.
My car has covered 120k and it has only just started moving. It is actually a proper bearing very similar to the one at the top end, but maybe the balls are a little smaller. Both the bearings did seem to be a little dry so I managed to push a bit of moly grease into them, easier said than done on the lower one. I had to use cotton bud, with the cotton removed. The only access to the ball race is through two small openings in the centre tube.
__________________
Rover 75 2.0 CDTi (131Ps) Conn SE Saloon. (Manual) 160 Remap, cruise control, electric window blind, temp gauge, Real walnut / ZT interior, FBH with GSM control. BORN Tuesday, 5th October 2004 @ 12:35:52 This vehicle was the 104,679th 75 to run off the production line, out of 112,381 This vehicle was the 3,318th 75 CDT Connoisseur SE (135) to be made out of 4,744 This vehicle was the 12,440th 75 in Starlight Silver (code: MBB) to be made out of 14,280 Starlight Silver 75s |
26th September 2020, 11:57 | #25 | |
This is my second home
Roverless + 1.7D Sportage Join Date: Aug 2014
Location: East Norfolk
Posts: 7,050
Thanks: 729
Thanked 2,021 Times in 1,449 Posts
|
Quote:
Sent from my SM-G903F using Tapatalk
__________________
Oil in my veins! |
|
26th September 2020, 14:34 | #26 |
Posted a thing or two
Rover 75 CDTi Saloon & Citroen C1 Join Date: Jun 2016
Location: Oakenshaw, Near Bradford
Posts: 1,622
Thanks: 385
Thanked 552 Times in 328 Posts
|
Very, i may never walk right again lol
__________________
Rover 75 2.0 CDTi (131Ps) Conn SE Saloon. (Manual) 160 Remap, cruise control, electric window blind, temp gauge, Real walnut / ZT interior, FBH with GSM control. BORN Tuesday, 5th October 2004 @ 12:35:52 This vehicle was the 104,679th 75 to run off the production line, out of 112,381 This vehicle was the 3,318th 75 CDT Connoisseur SE (135) to be made out of 4,744 This vehicle was the 12,440th 75 in Starlight Silver (code: MBB) to be made out of 14,280 Starlight Silver 75s |
|
|