New here need some advice

Nigpercival · 18th January 2012, 22:50

Hi might be asking a question that's asked all time but can I fit a highline system from a 03 75 into a t plate 75 if so difficulty level etc have comPlete system all wires etc still in doner car any advice greatly accepted

Reebs · 18th January 2012, 22:55

The hardest bit is putting the cable harness in. It needs to stretch the length of the car under the carpets and centre console. Not an impossible job, but quite involved. A few members have done it. Best of luck.

Neil Coupland · 19th January 2012, 09:02

I've fitted one recently and it is relatively straight forward; but be prepared to take a lot of trim apart

If the system is still in the donor car then you can easily see where every thing will fit. Start the install at the back and work forward so that the connection to the car's wiring harness is the last operation.

Routing the harness through the car is the awkward part.

Good luck, Neil

18th January 2012, 22:50	#1
Nigpercival Retired Rover 75 saloon Join Date: Jan 2012 Location: Seaham Posts: 436 Thanks: 0 Thanked 0 Times in 0 Posts	New here need some advice Hi might be asking a question that's asked all time but can I fit a highline system from a 03 75 into a t plate 75 if so difficulty level etc have comPlete system all wires etc still in doner car any advice greatly accepted

18th January 2012, 22:55	#2
Reebs Owners Club Director Rover 75 Conn SE V6 / MG ZT 260 SE V8 / MG ZT 180 SE V6 Join Date: Feb 2007 Location: Southampton Posts: 20,941 Thanks: 645 Thanked 6,851 Times in 2,537 Posts	The hardest bit is putting the cable harness in. It needs to stretch the length of the car under the carpets and centre console. Not an impossible job, but quite involved. A few members have done it. Best of luck. __________________ Check your trim here . Check your spec here Check your colour here . Check Project Drive here Check your original price here

19th January 2012, 09:02	#3
Neil Coupland Gets stuck in Range Rover Sport, MG TF 160 Aubergine Join Date: Nov 2006 Location: Nottingham Posts: 693 Thanks: 21 Thanked 20 Times in 17 Posts	I've fitted one recently and it is relatively straight forward; but be prepared to take a lot of trim apart If the system is still in the donor car then you can easily see where every thing will fit. Start the install at the back and work forward so that the connection to the car's wiring harness is the last operation. Routing the harness through the car is the awkward part. Good luck, Neil