|
||
|
22nd May 2018, 18:04 | #1 |
Newbie
MG ZT Join Date: Jan 2018
Location: Leicester
Posts: 23
Thanks: 1
Thanked 2 Times in 2 Posts
|
VIS motor screws
I've had my VIS motors off a couple of times to test them, and I'm getting a bit worried about stripping the heads of the screws holding them on. I found the part numbers and tried to order some replacements but apparently no-one has any stock!
Anyone know if they match up to a standard screw I could buy from B&Q? Or have any suggestions where to go? |
23rd May 2018, 07:06 | #2 |
Vis Whiz
Rover 75 2.5 auto Saloon Join Date: Jun 2007
Location: LEEDS
Posts: 20,587
Thanks: 2,057
Thanked 3,056 Times in 1,621 Posts
|
You don't need to remove the motors to test them. If you send me your address I will have some spares that I could send you.
__________________
Dave... Lost a few stones and a Gall Bladder and part of a bile duct and all of my dignity in the suppository incident |
23rd May 2018, 11:41 | #3 |
Newbie
MG ZT Join Date: Jan 2018
Location: Leicester
Posts: 23
Thanks: 1
Thanked 2 Times in 2 Posts
|
I had to have the motors off to replace the check the butterly flap and the control arm, and I'm just paranoid about reusing screws! Thanks for the offer though, I'll send you a PM.
|
19th June 2018, 07:57 | #4 |
Vis Whiz
Rover 75 2.5 auto Saloon Join Date: Jun 2007
Location: LEEDS
Posts: 20,587
Thanks: 2,057
Thanked 3,056 Times in 1,621 Posts
|
Did you get these? I initially forgot about them but then sent you four of each last week?
__________________
Dave... Lost a few stones and a Gall Bladder and part of a bile duct and all of my dignity in the suppository incident |
|
|