Couriers just been

[thomas 75 connie]

OOh im so excited the courier has just been and dropped of my package



Cannot wait to get this fitted into my car.

Just a quickie what would you use to clean the buttons etc as some are a little grubby thanks Thomas

[tweek08]

Originally Posted by thomas 75 connie

OOh im so excited the courier has just been and dropped of my package



Cannot wait to get this fitted into my car.

Just a quickie what would you use to clean the buttons etc as some are a little grubby thanks Thomas

Anyone else selling one of these

[thomas 75 connie]

Originally Posted by tweek08

Anyone else selling one of these

I must admit i lucked out. They seem to be around the £150 to £200 mark and this one was up for £129 So i offered them £60 expecting either a sharp no or an offer. They came back with £120 but i messaged them saying sorry i only have about £70 to which the said £80 delivered which i accepted

Didnt expect it to be that cheap

[blowncrv]

Just use a baby wipe works good on grubby hand prints or use a cotton bud wetted in APC and squeezed almost dry to get in between.

[thomas 75 connie]

Originally Posted by blowncrv

Just use a baby wipe works good on grubby hand prints or use a cotton bud wetted in APC and squeezed almost dry to get in between.

Thankyou sir ill do that thanks again Thomas

[coolcat]

Hi Thomas, you will need to cut the plastic ears off the side to allow it to fit as well Sir
Junior Hack Saw will do the job and remember it will be hidden when fitted

[thomas 75 connie]

Originally Posted by coolcat

Hi Thomas, you will need to cut the plastic ears off the side to allow it to fit as well Sir
Junior Hack Saw will do the job and remember it will be hidden when fitted

Thanks Jeff im tempted to go out and try test fit it now

How do i get the old highline out do i take the eyebrow off?

[coolcat]

Originally Posted by thomas 75 connie

Thanks Jeff im tempted to go out and try test fit it now

How do i get the old highline out do i take the eyebrow off?

Take the eyebrow off, unscrew the two screws holding the radio and remove the air con unit which will give you access to push the two tangs at the bottom of the radio in, radio should then release and you will have the two connectors to undo behind

[Neil1]

Is it a radio or satnav?

[thomas 75 connie]

Originally Posted by coolcat

Take the eyebrow off, unscrew the two screws holding the radio and remove the air con unit which will give you access to push the two tangs at the bottom of the radio in, radio should then release and you will have the two connectors to undo behind

Thanks Jeff ill give it a go