|
||
|
3rd July 2019, 17:39 | #1 |
Newbie
Rover 75 Saloon Join Date: Jun 2016
Location: Guyhirn
Posts: 14
Thanks: 2
Thanked 7 Times in 1 Post
|
Door card removal
When removing door cards, ignore Haynes, they make it difficult!
Simply unscrew the pull handle surround, unclip all around the edges, ensuring the clips all stay out of their holes, then nudge the panel upwards (from the bottom edge) effectively sliding the panel vertically upwards. this disengages the steel centre clips from the door. To replace the panel, remove the steel clip from it and replace in the door, on its bracket. The panel can then be nudged back into position, and the clips re-engaged by tapping the panel back into place, using a flat hand. make sure the handle is correctly placed, and that the wire link has not been disconnected. Job done, time taken to remove and replace 5 mins. This post is for those who don't know the trick!!! |
21st July 2019, 21:04 | #2 |
Regular poster
Rover 75 Join Date: Jan 2016
Location: a
Posts: 84
Thanks: 49
Thanked 20 Times in 16 Posts
|
I had to do this today for a rear door and I'd recommend putting some duck tape over the back of the small speaker as it is only lightly clipped in. Otherwise when you thump the door card, at the top, to locate it, the speaker will keep falling out.
|
|
|