|
||
|
|
26th December 2019, 10:11 | #1 |
This is my second home
Rover 75 CDT-2001 Join Date: Jan 2009
Location: Wrexham, North Wales
Posts: 3,606
Thanks: 195
Thanked 606 Times in 501 Posts
|
Water on the boot lid seal near the hinge
I have water entering the boot over the boot lid seal somehow.
Just by the drivers side boot hinge the seal is wet there, which then runs down and drips behind the wheel arch on to the bit of carpet on the right hand side of the floor board. The seal appears in good condition, i cant see why this is happening. Any clues? |
26th December 2019, 11:08 | #2 |
This is my second home
rover 75 1.8 vvc club se wedgwood blue Join Date: Aug 2009
Location: Seaton Carew
Posts: 26,921
Thanks: 65
Thanked 7,142 Times in 4,642 Posts
|
Hi David, I spent weeks chasing the same leak. My observations were, the boot seal has air holes in it, so when you close the lid, it lets out air and prevents the lid bouncing, I sealed the hole nearest the leak.
Also, I had a rip in the window seal near the top, discovered water was getting in through the clip, down the window inside the boot lid, dripping down into the boot. Sealed with Captain Tolley's along the top, sealant underneath, and now, touch wood, all dry. If MG/Rover made submarines eh |
26th December 2019, 11:36 | #3 | |
This is my second home
Rover 75 CDT-2001 Join Date: Jan 2009
Location: Wrexham, North Wales
Posts: 3,606
Thanks: 195
Thanked 606 Times in 501 Posts
|
Quote:
|
|
26th December 2019, 14:28 | #4 |
This is my second home
Rover 75 CDT-2001 Join Date: Jan 2009
Location: Wrexham, North Wales
Posts: 3,606
Thanks: 195
Thanked 606 Times in 501 Posts
|
I have cleaned all around the gutter area, which was full of pine needles and dirt, then i removed the seal. There was a build up of dirt all the way under the lip of the seal, so I cleaned all that away, washed the seal out as well, then applied wax polish all around the gutter in the hope that if the rain runs out of the gutter faster it wont track around the seal and in to the boot. Time will tell.
|
12th January 2020, 19:16 | #5 |
Gets stuck in
MG ZT 260, Rover 75 Connie SE auto Join Date: Feb 2013
Location: Redruth
Posts: 984
Thanks: 1,324
Thanked 399 Times in 271 Posts
|
Leaking New boot seal.
On my MG ZT saloon I had fitted a brand new boot seal since I'd done everything else. I resented the extra £50 even more when I still had water in the boot.
Long story, short version. The boot seal is badly designed and even a new seal often fails (in my opinion now) to keep water out of the boot. If the boot lid doesn't compress the seal evenly it flows over the top, but worse it can flow under the seal just below the rear screen, track down and then emerge on the boot side lower down. I applied silicone sealant to my brand new boot seal along the entire fitting surface. since then, no more water in my boot. The underlay sponge was dried out first by lots of towels and then by putting scrap wood spacers under the felt/carpets to raise them and leaving a small dehumidifier in the car. Takes a few days of persistence and is much easier in the summer or a dry garage of course. |
13th January 2020, 17:47 | #6 |
This is my second home
R75 Saloon. Join Date: Feb 2009
Location: France/or Devon.
Posts: 14,003
Thanks: 3,851
Thanked 2,167 Times in 1,816 Posts
|
Sometimes, just sometimes a coating of wax polish does the trick.--
|
26th January 2020, 22:20 | #7 |
Avid contributor
Rover 75 tourer 131bhp Join Date: Sep 2019
Location: co.meath
Posts: 139
Thanks: 42
Thanked 52 Times in 32 Posts
|
hi ,
i had to remove the hinge as it was leaking where the bolts are, as well as the rear lights/ the side chrome strip on both sides silicone done the trick and the badge emblem is a ship how ironic i have pic post some wear on the site of the damage the leaks done to my car . rob
__________________
pink floyd playing wile driving a rover The Raven . |
|
|