|
||
|
25th May 2019, 18:01 | #1 |
Gets stuck in
MGZT-T Join Date: Oct 2014
Location: Paignton
Posts: 618
Thanks: 278
Thanked 90 Times in 72 Posts
|
KV6 overheating
Mg zt-t 190.
Hi all, Out and about last night when the engine overheat flashed on the IPK for a few seconds and went out. The engine temp indicator maxed, then slowly returned to normal. Luckily I was at the top of the hill, so in neutral with the engine idling, I managed to get home without any serious overheat. This morning, put around 3 litres in the system, bled it on the engine hose, and started up. Looking at the torque ap, temp rose to normal, then slowly crept up to 96. After a few minutes I revved the engine to 3000rpm for a moment or two, the temp went up to 102. I shut it down. During this routine the high speed fan on the rad came on and off sporadically. When the engine was off and cooled to around 70, I turned on demist, the interior fan came on, but the rad fan didnt, same happened when I tried the air con on lo. I didnt seem to lose any fluid during this time, even when the temp went over 100 so I am assuming the thermostat housing is ok? Any thoughts on the cause before I start messing around and making it worse? Phil |
25th May 2019, 18:13 | #2 |
Gets stuck in
MG ZT 190 Join Date: Oct 2011
Location: Nottingham
Posts: 972
Thanks: 120
Thanked 90 Times in 78 Posts
|
is your fan working properly.i think you may need a new resistor or new bushes sorry didnt check age of your car.
Last edited by grs6680; 25th May 2019 at 18:17.. |
25th May 2019, 18:31 | #3 |
Vis Whiz
Rover 75 2.5 auto Saloon Join Date: Jun 2007
Location: LEEDS
Posts: 20,593
Thanks: 2,057
Thanked 3,056 Times in 1,621 Posts
|
Your radiator fan should come on low speed at around 100 and stay on until 95. If it doesn't then you have a problem with the fan, that could be a failed resistor, relay or fan brushes.
Regardless of this your car shouldn't overheat just because of a failed slow speed fan, the next speed should come on at around 106 and cool the engine. It could be a combination of a failed low speed fan and a sticking thermostat. 1st job is to find out if you have a 2 or 3 speed fan.
__________________
Dave... Lost a few stones and a Gall Bladder and part of a bile duct and all of my dignity in the suppository incident |
25th May 2019, 19:00 | #4 |
Gets stuck in
MGZT-T Join Date: Oct 2014
Location: Paignton
Posts: 618
Thanks: 278
Thanked 90 Times in 72 Posts
|
Thanks Dave and Gordon,
How do I check what fan set up I have? It's an 03 reg. |
25th May 2019, 19:52 | #5 | |
Vis Whiz
Rover 75 2.5 auto Saloon Join Date: Jun 2007
Location: LEEDS
Posts: 20,593
Thanks: 2,057
Thanked 3,056 Times in 1,621 Posts
|
Quote:
if not it is (almost) certain you have the older type 3 speed fan.
__________________
Dave... Lost a few stones and a Gall Bladder and part of a bile duct and all of my dignity in the suppository incident |
|
25th May 2019, 20:07 | #6 | |||
Doesn't do things by halves
Rover 75 2.5 Connoisseur Auto (1999) Dealer launch model. Join Date: Mar 2007
Location: Former Middlesex
Posts: 20,455
Thanks: 1,587
Thanked 3,749 Times in 3,181 Posts
|
Hi Phil,
Quote:
When you bled the cooling system, did you raise the expansion tank with the engine not running? Quote:
Quote:
Simon
__________________
"Whatever is rightly done, however humble, is noble." Sir Henry Royce. |
|||
25th May 2019, 22:37 | #7 |
Gets stuck in
MGZT-T Join Date: Oct 2014
Location: Paignton
Posts: 618
Thanks: 278
Thanked 90 Times in 72 Posts
|
Thanks Simon and Dave, I'll make those checks tomorrow PM, when I return from work, and post the results.
|
26th May 2019, 08:31 | #8 | ||
Doesn't do things by halves
Rover 75 2.5 Connoisseur Auto (1999) Dealer launch model. Join Date: Mar 2007
Location: Former Middlesex
Posts: 20,455
Thanks: 1,587
Thanked 3,749 Times in 3,181 Posts
|
Phil; it's also important that we address this:
Quote:
Quote:
Simon
__________________
"Whatever is rightly done, however humble, is noble." Sir Henry Royce. |
||
27th May 2019, 17:09 | #9 |
Gets stuck in
MGZT-T Join Date: Oct 2014
Location: Paignton
Posts: 618
Thanks: 278
Thanked 90 Times in 72 Posts
|
Managed to have a look at the fan this afternoon.
There is no resistor visible. There are the two screw holes on the housing which look like where the resistor should be. Started the engine and left it on idle. Engine temperature climbed to 96, fan didn't come on. Temperature climbed to 107, still no response from the fan. I bottled out then and turned the demist on. The fan came on and the engine temperature quickly dropped to 102 within around 1 minute. Leaving the demist on and fan running, the temperature dropped to 96 within six minutes. It then continued to hover between 96 and 97. Any thoughts. Phil |
27th May 2019, 20:11 | #10 | |
Doesn't do things by halves
Rover 75 2.5 Connoisseur Auto (1999) Dealer launch model. Join Date: Mar 2007
Location: Former Middlesex
Posts: 20,455
Thanks: 1,587
Thanked 3,749 Times in 3,181 Posts
|
Hi Phil,
Thanks for the test results. However, my diagnosis depends upon your answer to my earlier question: Quote:
Simon
__________________
"Whatever is rightly done, however humble, is noble." Sir Henry Royce. |
|
|
|