|
||
|
19th October 2018, 18:20 | #1 |
Gets stuck in
MG ZT 2.5 V6 Auto Tourer (Elizabeth) / MG ZT CDTI (Farage) Join Date: Jan 2017
Location: St Helens
Posts: 688
Thanks: 339
Thanked 109 Times in 89 Posts
|
Help with FBH installation
Hi guys hope someone can help. I finally got round to fitting my FBH today - I bought it last September (2017) so not doing too bad lol. The burner is in and plumbed so no issues there, however, I have run into a few other fiddly problems:
1. The 6 pin plug in the engine bay doesn't fit the heater- the 2 pin is fine but the 6 pin is different? 2. The dosing pump plug I dropped down from the fuel tank doesn't fit the pump... 3. My pump has a rubber bracket which seems a great solution if I was to take one of the bolts out of what looks like the old bracket base and attach it but I'd need a letter from God to get them off - both just turned to mush and are now perfectly round ... Tried hammering on smaller sockets etc they just disintegrated. Any ideas on best place to attach? 4. There was a Siemens box ziptied to the side of the fuse box I had to remove to fit the fbh in place. I've ziptied it slightly further away but it's not entirely secure and seems to have some clips on to attach it somewhere else. What is it and where is supposed to be?? Any help much appreciated - pictures below: https://ibb.co/eZqhy0 https://ibb.co/cKGcWL https://ibb.co/hdRY5f Last edited by BillyMG; 19th October 2018 at 18:31.. |
|
|