2003 rover 75 1800 petrol non start fuel problem

[T-Cut]

Use a multimeter to check the motor resistance. If the reading is 'infinite' (open circuit) then it's had it and should be replaced. The normal resistance is shown in the diagram.



TC

[Yorkshire GOC]

Originally Posted by vitesse

As the car is a 2003 then I would expect the later type filter, or the one that the clip was produced for.

OK you put power directly to the pump and didn't hear anything but did you ensure the black cable or pin was earthed? And you lifted the rear seat and removed the normal plug on the fuel filter to do this?

Sorry I've no idea where to find the crank sensor on a 1.8 (only have V6s), use the search bar. But as the needle does move I would think the sensor is fine.

Regards

The cranksensor is on the Bell housing behind the turbo.