zt diesel auto error codes

obi · 12th September 2009, 16:34

have a 54 zt-t diesel auto with 127000 miles on and recently had the engine management light come on got the codes read and it came up with 4 as follows:3505 glow time control, 1260 fuel pressure first stage check, 480 radiator fan control and 100 air flow meter. would like a little advice as to how serious these are and if they are needing looked at sooner rather than later, i have pierburgh air flow meter with a tu3 box fairly recently fitted would this have any bearing on these codes especially the last one
interestingly though the light is now off (it went off the day before i took it to get read) and has stayed off up until now(about a week),please help as i have got kind of attached to the old beast and wouldn't like to have to get it put down just yet

stocktake · 12th September 2009, 17:43

Hi there,

What did you use to get the codes? where abouts are you?

If it was not a T4 machine the codes will be generic and may not relate correctly. If it was a T4, in the right hands should be self explanitory

obi · 19th September 2009, 20:19

Quote:

Originally Posted by stocktake

Hi there,

What did you use to get the codes? where abouts are you?

If it was not a T4 machine the codes will be generic and may not relate correctly. If it was a T4, in the right hands should be self explanitory

i'm not sure if it was a t4 ,as it's my brother in laws garage and is the machine he uses for general diagnostic work, by the way i'm near carlisle

12th September 2009, 16:34	#1
obi Newbie MG ZT T Join Date: May 2009 Location: carlisle Posts: 9 Thanks: 0 Thanked 0 Times in 0 Posts	zt diesel auto error codes have a 54 zt-t diesel auto with 127000 miles on and recently had the engine management light come on got the codes read and it came up with 4 as follows:3505 glow time control, 1260 fuel pressure first stage check, 480 radiator fan control and 100 air flow meter. would like a little advice as to how serious these are and if they are needing looked at sooner rather than later, i have pierburgh air flow meter with a tu3 box fairly recently fitted would this have any bearing on these codes especially the last one interestingly though the light is now off (it went off the day before i took it to get read) and has stayed off up until now(about a week),please help as i have got kind of attached to the old beast and wouldn't like to have to get it put down just yet

12th September 2009, 17:43	#2
stocktake Vis Whiz Rover 75 2.5 auto Saloon Join Date: Jun 2007 Location: LEEDS Posts: 20,591 Thanks: 2,057 Thanked 3,056 Times in 1,621 Posts	Hi there, What did you use to get the codes? where abouts are you? If it was not a T4 machine the codes will be generic and may not relate correctly. If it was a T4, in the right hands should be self explanitory __________________ Dave... Lost a few stones and a Gall Bladder and part of a bile duct and all of my dignity in the suppository incident