|
||
|
21st May 2014, 09:07 | #1 |
Regular poster
Rover 75 CDTi connoisseur Join Date: May 2014
Location: Ashford
Posts: 38
Thanks: 14
Thanked 2 Times in 2 Posts
|
75 CDTi shocks
Hi guys, This is my first post on here, having just bought our 75 cdti se connoisseur. Its 2004, 117000mls.
Came with service book stamped every year since new, bodywork very good, inside spotless, looks well looked after. But we bid and purchased it at a car auction, so expected we may a problem or two, even though it had a full years MOT having just been done 2 days prior to auction and NO ADVISORIES. shown. Well as soon as we drove it away we had a knocking and the steering was bit wandery. Got it on a lift and found that the MOT guy needs to go to specsavers. N/S/F shock needs replacing Both wishbone rear bushes completely knackered O/S tie rod needs to be replaced. The knocking is top Drivers side engine mount, the hydramount. I am no mechanic but I plan to sort those things out. My priority is the steering, although it does not feel bad, I hate the thought of it not being A1 I have a couple of Q? Shocks. Do I replace both fronts for new, or fit a single second hand one? If I go for replacing both front shocks for new, and I am tempted, are there good and not so good shocks on the market? Although I cannot see wear on the lower engine mounts, I do wonder if the excessive engine movement at the hydramount (I do not know how long its been driven with this knock, knock, knock, it may have been for some time) would have been bad on the rubber bushing on the other mounts and I will be needing to replace them as well soon. I see I can get polybush engine mount replacements and while I am at it i can get a bush kit for the suspension and do the lot. We actually only went to auction for a little hatchback type run around for temporary use while our other car is being repaired. BUT, my wife Jane has fallen in love with this 75 se connoisseur, even though its 10 year old, she cant think of any reason she would want to change it, especially as we could never afford a new car of this spec. I don't know cars, I just drive them, but now I have done a bit of looking into the 75 CDTi and realized it has a BMW lump does 40ish mpg I am also very muck looking forward to keeping it. And I have saved some dosh! Therefore, in your opinion would it make a much better car/ride if I replace all suspension and steering bushes, or am I just throwing money at it unnecessarily and only replace what I know has failed, and replace other items as and when it comes to light or picked up at MOT. Thanks Steve. Last edited by steveandjanes75; 21st May 2014 at 09:40.. |
21st May 2014, 10:20 | #2 |
Regular poster
MG ZT diesel auto Join Date: Aug 2012
Location: ANGUS
Posts: 33
Thanks: 0
Thanked 10 Times in 9 Posts
|
You will need to do both front shocks and as far as I am aware there are no aftermarket sets available for the diesel. Done mine last year and they were around £80 each from Rimmer Bros. When you do them make sure you get the springs, drop links and strut bearings replaced at the same time. The rubber stops on the strut had disintegrated on mine as well so it might be worth ordering all the strut components. The job itself is pretty straight forward in theory and there are "how to's" with pics on the forum. The biggest problem is the bolt that runs through the strut carrier on the hub. If it's not been touched for years it can be a real ****** to get out. Plenty penetrating fluid and or heat plus a good quality breaker bar with an impact socket done the trick on mine but it was a lot of effort. Make sure you have good quality spring compressors as well for the heavy duty springs. It,s a good few hours job if everything comes off as it should but can take a lot longer if you have seized bolts.
Last edited by wmj; 21st May 2014 at 10:23.. |
21st May 2014, 10:44 | #3 |
Gets stuck in
Rover 75 Tourer Connoisseur SE Join Date: Jan 2012
Location: Newbury
Posts: 836
Thanks: 9
Thanked 101 Times in 91 Posts
|
A common fault on the diesels is not the hydramount, but the lower engine mount.
It is a very easy fix - there is a how-to. The problem is which mount to use as a replacement - there is much discussion on the forum about using the OEM at about £70-80 or simply fitting a yellow Powerflex bush for £25. Opinion is divided. The 'looseness' in the steering is most like play in the rear wishbone bushes and I would not take any further action with this until the suspension repairs are complete. There are other things that you should check as well - see the forum. Chief among these are the plenum and fan operation Lastly, you must report the MoT tester/garage to VOSA. For someone who is not mechanically aware, the faults you described that have been missed could prove to be fatal. Last edited by berkshirelad; 21st May 2014 at 10:48.. |
21st May 2014, 10:46 | #4 |
Gets stuck in
Rover 75 Tourer Connoisseur SE Join Date: Jan 2012
Location: Newbury
Posts: 836
Thanks: 9
Thanked 101 Times in 91 Posts
|
|
21st May 2014, 11:21 | #5 | |
Regular poster
MG ZT diesel auto Join Date: Aug 2012
Location: ANGUS
Posts: 33
Thanks: 0
Thanked 10 Times in 9 Posts
|
Quote:
Tie rods are available aftermarket, cheap and easily picked up at most motor factors Last edited by wmj; 21st May 2014 at 11:29.. |
|
21st May 2014, 11:27 | #6 |
Gets stuck in
2003 ZT-T CDTI '+' a ZT Join Date: Jun 2010
Location: N/E Herts
Posts: 977
Thanks: 4
Thanked 42 Times in 36 Posts
|
I know we all like our car to pass and maybe given the benefit of the doubt re non dangerous faults but if it is as you describe that's more than a poor mot tester !
I would definitely speek to vosa who may be more interested than you think. They can check the mot history too (as can you) online. I'll bet that gives a huge clue what may have gone on here. You have a few Bob to spend , I'm glad you are still keen on your car Mas
__________________
☆☆☆☆☆☆☆☆☆☆☆☆☆☆ |
21st May 2014, 12:50 | #7 |
Regular poster
Rover 75 CDTi connoisseur Join Date: May 2014
Location: Ashford
Posts: 38
Thanks: 14
Thanked 2 Times in 2 Posts
|
|
21st May 2014, 12:55 | #8 | |
Regular poster
Rover 75 CDTi connoisseur Join Date: May 2014
Location: Ashford
Posts: 38
Thanks: 14
Thanked 2 Times in 2 Posts
|
Quote:
|
|
21st May 2014, 12:58 | #9 |
Regular poster
Rover 75 CDTi connoisseur Join Date: May 2014
Location: Ashford
Posts: 38
Thanks: 14
Thanked 2 Times in 2 Posts
|
Thanks for that info.
|
21st May 2014, 13:03 | #10 |
Gets stuck in
Rover 75 Tourer Connoisseur SE Join Date: Jan 2012
Location: Newbury
Posts: 836
Thanks: 9
Thanked 101 Times in 91 Posts
|
|
|
|