Diesel Inlet Manifold Sensor wire retaining clip

[MarkS]

On the diesel inlet manifold by the offside, there is a sensor with the mating connector retained by a bright spring wire steel retaining clip.
Mine flew off on removing the connector.

[macafee2]

pm me your address and email address, I will send you a photo to make sure I'm looking at the right thing and if I am I will put one in the post to you.


macafee2

[Arctic]

Hi Ian.
It will be this one below.
1

Its for the three prong connector not the two below which is a smaller spring clip
2

[macafee2]

Originally Posted by Arctic

Hi Ian.
It will be this one below.
1

Its for the three prong connector not the two below which is a smaller spring clip
2

thank you Arctic, I thought it was that type but wanted to be sure. I'm pretty sure I saw one on the bench this afternoon but if not I have a spare on a harness.

macafee2

[MarkS]

Is it the Turbocharger boost pressure sensor ?
I will check the number of connections and wire colours tomorrow.

Many thanks for the help, all.

[Arctic]

Hi Mark.
It's the MAP sensor connector spring clip, a lot of people pull the spring clip outwards when trying to remove the sensor, but you have to press them in then the plug disconnects.

[MarkS]

I don't seem to be able to gives thanks.
Thank you anyway.

[MarkS]

Originally Posted by macafee2

pm me your address and email address, I will send you a photo to make sure I'm looking at the right thing and if I am I will put one in the post to you.


macafee2

Received.

Thank you very much Ian.

[macafee2]

Originally Posted by MarkS

Received.

Thank you very much Ian.

you are welcome thank for letting me know.
If you could drop a quid or to into a charity box that would be appreciated, thanks

macafee2