Go Back   The 75 and ZT Owners Club Forums > The 75 and ZT Owners Club Forums > The 75 and ZT Owners Club General Forum
Register FAQ Image Gallery Members List Calendar Search Today's Posts Mark Forums Read
Notices

Reply
 
Thread Tools Display Modes
Old 5th June 2022, 11:08   #1
stocktake
Vis Whiz
 
stocktake's Avatar
 
Rover 75 2.5 auto Saloon

Join Date: Jun 2007
Location: LEEDS
Posts: 20,223
Thanks: 1,990
Thanked 2,981 Times in 1,576 Posts
Default What's your biggest Bodge?

Having a conversation with a member about when times were hard and you struggle to make ends meet, I'm sure many of us have had to make do and mend to either get home or get to the end of the month to effect the "correct" repair.

Who is brave enough to admit a bodge, sorry I mean a workaround...

I once owned a Triumph Herald in my twenties and snapped a rear half shaft. Couldn't afford a replacement so bolted a length of angle iron to the flange on the diff and then secured the angle iron to the chassis outrigger with an exhaust clamp to stop it from moving. One wheel drive kept me going....

Over to you

Edit: I don't consider over riding safety systems a Bodge so don't even bother posting them.............
__________________
Dave...



Lost a few stones and a Gall Bladder and part of a bile duct and all of my dignity in the suppository incident

Last edited by stocktake; 5th June 2022 at 11:16..
stocktake is offline   Reply With Quote
Old 5th June 2022, 11:21   #2
Arctic
Give to Learn
 
Arctic's Avatar
 
Rover 75 Tourer

Join Date: Aug 2010
Location: West Midlands
Posts: 16,960
Thanks: 1,097
Thanked 6,113 Times in 3,694 Posts
Default

Yesterday on an intercooler, which had been fitted broken by someone else, whom shall not be named at the moment, owners permission given for the work around not a bodge which knowing you Dave yours would have been a good work around not a bodge until you could get it sorted.

Said intercooler as it had no supporting ring brackets.

1
__________________
Arctic
Givology Learn to Give
Everything is Achievable

ad altiora tendo.

Check out our Nano meet dates
http://www.midlandsnanomeets.co.uk/

http://www.the75andztclub.co.uk/index.php?thepage=howto

" You do the work , we supply the expertise "
Arctic is offline   Reply With Quote
The Following User Says Thank You to Arctic For This Useful Post:
Old 5th June 2022, 12:02   #3
roverbarmy
This is my second home
 
roverbarmy's Avatar
 
Roverless + 1.7D Sportage

Join Date: Aug 2014
Location: East Norfolk
Posts: 6,328
Thanks: 699
Thanked 1,973 Times in 1,411 Posts
Default

Not on a Rover but brought a truck back using a gallon can of diesel hung on a coat hook in the cab, using the gravity feed to the 4D Ford diesel pump on the engine, via a length of rubber fuel pipe, when the lift pump failed! It took three can refills (syphoned from the tank) to get back to the yard!
__________________
Oil in my veins!
roverbarmy is offline   Reply With Quote
The Following 2 Users Say Thank You to roverbarmy For This Useful Post:
Old 5th June 2022, 15:50   #4
Ducati750cc
Loves to post
 
Rover75 tourer

Join Date: Jun 2018
Location: Ashton
Posts: 319
Thanks: 112
Thanked 190 Times in 133 Posts
Default

Many many years ago in the pouring rain we get up here on the Woodhead Road I came across four students in an old Mini in a lay-by with the bonnet up doing a bit of head scratching because the wipers had stopped.


I offered to have a look thinking it would be the usual sloppy ball joint that a bit of baling wire or cable tie would sort, nope the motor had seized and they weren't in any breakdown organisation.


After a bit of head scratching on my part I popped the crank ball joint off, scavenged about ten foot of bailing twine and made a nice set up to use the front passenger as a wiper motor, with his arm action it looked like he was paddling the car along


I followed them down to civilization and about five miles to the uni, just in case, but it worked OK all the way.


I used to come across lots of stragglers up here and made one or two hand throttles out of the choke cable and such like.


The nicest one was coming across a young couple broken down in an old VW on a very bad bend at dusk with no lights on not far from my home, decided that the nearest safe spot was my place, a quick glance confirmed a low battery and the alt not charging.


Off it came, battery on charge and I discovered the slip rings were worn right through, nothing in my junk pile to use so wound and soldered them with some copper wire, a bit of file work and wet and dry and they looked like two wedding rings, a pair of brushes from a scrap alt I had soldered in, a cross your fingers and it was whacking in a good charge.


Meanwhile the late Mrs. Ducati had fed and watered them and discovered they were newly married and were on the way to their honeymoon, they got to their destination and had a new alt fitted the next day.


Ahh the days of make do and codge sadly gone, rolled up silver paper, when the dizi cap brush has worn away, a couple of eggs or porridge for a leaky rad, nail varnish for a cracked dizi cap and a stick of Chemical Metal that would fix anything,especially a pin holed core plug at the back of the block
__________________
Common sense isn't a gift, it's a punishment because you have to deal with everyone who doesn't have it.
Ducati750cc is offline   Reply With Quote
The Following 2 Users Say Thank You to Ducati750cc For This Useful Post:
Old 5th June 2022, 15:55   #5
cbr1100xx
Gets stuck in
 
mg zt+ cdti

Join Date: Mar 2015
Location: dunsop bridge
Posts: 848
Thanks: 222
Thanked 398 Times in 227 Posts
Default

Me dad once had a little nissan sunny and forgot about the mot, when he realised that it had run out,took it to the local garage where it failed on a rusty sill.
Back home , got an old biscuit tin out of the shed , folded it over 3 or 4 times and pop rivetted it on.
Bit of filler , coat of underseal and back to the garage within a hour.
Passed with flying colours but the tester was a bit baffled as to how he welded so quick and made it look so neat and tidy.

Stan
__________________
WE WERE BOTH BORN ON THE 4th of JULY
cbr1100xx is offline   Reply With Quote
Old 5th June 2022, 20:00   #6
SCP440
I really should get out more.......
 
SCP440's Avatar
 
MG ZT-T 260

Join Date: Feb 2016
Location: Witney
Posts: 2,374
Thanks: 6
Thanked 890 Times in 560 Posts
Default

About 30 years ago I was in Aachen in Germany in a 3.0 Capri, a couple of days into the stay I noticed we seem to be getting through a lot more Petrol than usual. At a petrol station the person filling his car up behind me came over and started shouting at me in German ( I dont speak a word apart from being able to order beer) Any way he pointed to the underside of my car and there was a large puddle of petrol under the car.


After some investigation I found several holes probably rust perforation and of course near the botton of the tank, I purchase some Petro Patch or equivalent and tried to patch up the tank, as I did this the holes got bigger.


Plan B was a 5 gallon Jerry can purchased from a Hardware shop and some pipe. After a bit of work the Jerry can was supplying the engine.


The problems were we had no gauge and of course with only 5 gallons we ended up stopping about 7 or 8 times just to make sure we didnt run out of fuel.



In hindsight I should have purchased 2 Jerry cans but we got home and had some very odd looks pulling the boot open and putting the petrol in there, on one occasion I achieved nearly 30mpg.
SCP440 is offline   Reply With Quote
Old 5th June 2022, 21:28   #7
BillyMG
Gets stuck in
 
BillyMG's Avatar
 
MG ZT 2.5 V6 Auto Tourer (Elizabeth) / MG ZT CDTI (Farage)

Join Date: Jan 2017
Location: St Helens
Posts: 678
Thanks: 333
Thanked 108 Times in 88 Posts
Default

Beer tins, jubilee clips and self amalgamating tape have saved the day for me on more than one occasion. I've patched up just about every hole you can imagine with those... But let's not forget the mighty metal coat hanger - I used one to re-hang the exhaust on my old Ford Orion, and another specially shaped to open the drivers door after the barrell became worn and the key just spun in the lock. However on one occasion after leaving work one Friday afternoon I noticed some ladies hygiene products in my door pocket and quickly realised I'd set off in somebody else's Orion! Same colour (white), same year, parked two cars down from mine in the office car park, and must have had the same wear to the key barrells!
BillyMG is offline   Reply With Quote
Old 5th June 2022, 22:33   #8
bsafly
Just going about!
 
bsafly's Avatar
 
Rover 75 CDTi Connie SE Tourer starlight silver and serpents. MG ZT-T 190+ in Raven Black.

Join Date: Mar 2016
Location: Great Leighs
Posts: 405
Thanks: 603
Thanked 160 Times in 105 Posts
Default

Not so much bodge, but get you home in a fix:
many from years ago, but two that stand out just now (after a little drink or two).
Taking my wife’s FB Victor for it’s first MOT in her ownership 20 years ago the core plug behind the dynamo mounting bracket let go and it dumped all its coolant rather quickly and noticing the temperature gauge rapidly rising stopped to investigate. I was carrying a full toolbox in the back, so I removed the dynamo and mounting bracket, found a suitable piece of tree branch at the side of the road (was travelling along a country road near Ingatestone), whittled it to the size of the defunct core plug with my penknife, pried the core plug out with a long screwdriver and hammered the wooden plug in, refitting the dynamo mounting bracket held it securely in place and some water from a pond at the side of the road had me back on my way. The car passed it’s MOT and the ‘repair’ held for a few weeks until I got round to fitting a full set of new core plugs.
On the way to work about 25 years ago in a colleague’s old Suzuki 4x4 it ground to a halt with some impressive backfires, the blade spring for the points had fractured and the points were just flapping around!
Out came the trusty pen knife, cut the L.T. wire at the points post, bared the end and wrapped it around the broken blade spring next to the moving contact to make the circuit, ripped a filter off a perfectly good cigarette, folded it in half and jammed it between the distributor body and moving contact, which kept the L.T. wire connected securely to the moving contact and shut it as it came off the cam.
That repair lasted 8 miles before the cigarette filter failed, another ruined cigarette saw us safely to work and a new set of points (ordered by the owner) fitted during lunch break saw it back on the road in time to get us home.
__________________
bsafly is offline   Reply With Quote
Old 6th June 2022, 08:29   #9
Saga Lout
This is my second home
 
MG ZT and Rover 75,

Join Date: Jul 2013
Location: Wigan
Posts: 3,174
Thanks: 2,529
Thanked 2,642 Times in 1,022 Posts
Default My bodge.

I used to be white van man a long time ago, I was in Birkenhead in a VW van and the throttle cable snapped, I still had many drops to do so I phoned the office to let them know and to get a new cable, I then popped out a bung on the bulkhead and fed the cable through into the cabin, this allowed me to pull the cable by hand but it was tricky changing the gears. It all worked out though. Another time I'd done a drop with a 7.5 tonne curtain side truck on the other side of Oxford, we pulled into Thame services for a stop on the way back. When I turned the key to start the engine, the starter just clicked and the lights went dim so I knew it had an electrical fault, it was getting dark and there was no way of getting it mended where it was, there was a slight gradient and I bump started the thing and set off up the motorway, by the time I got to Wigan the lights were almost gone and I rolled into the yard and killed the engine, left a note for the next driver and went home.
Saga Lout is offline   Reply With Quote
Old 6th June 2022, 18:15   #10
Bogbrush82
I really should get out more.......
 
Rover 75 2.0 CDTi

Join Date: May 2017
Location: Tipton
Posts: 2,190
Thanks: 50
Thanked 734 Times in 406 Posts
Default

Not one I did but getting the car MOT'd involved having to replace a stolen cat that had been repaired with scaffolding.
__________________
Current car: 2005 Honda CR-V in Cosmic Grey, and against my better judgment has become a resto project.
Bogbrush82 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 01:10.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright © 2006-2022, The Rover 75 & MG ZT Owners Club Ltd