DanBMXes zt 160

[danbmx_69]

so today we were at Castle comb




and when I get home and I am letting it idle for the run down on the turbo its decides to wee it's self



looks like yet another water hose has gone then

[generic_username]

Dan, were did you get the black oak stickers?

[danbmx_69]

I found some one doing them on here, I will try dig out the e mail address for you

[danbmx_69]

[email protected] this is the email ask him for a number sheet so you can choose what you want

[danbmx_69]

uploadfromtaptalk1404405271271.jpg


the car in it's current state, turns out the rad has gone on one of the plastic sides, and its only about a year old,

my crank shaft oil seal has been leaking for quite a while so it looks like there is no better time to tackle the job then now as the front end is off, I will also replace the slave cylinder and clutch while its off to save me going back there in the future, and I am also hoping once that's all done and because the front end is off I may carry out another modification, watch this space

[danbmx_69]

Here is photo's of the rad to show where it's gone look in the middle of the plastic part

[danbmx_69]

so here's today's update the gear box is off and this here really goes to show that you can never know a car's history, when I had this car it only had 45k on the clock and I was very surprised to take the gear box off and see that someone had been there before me and made a nice mess on the rear main oil seal,

[Seafrost]

Oh my.... how do you think they did that Dan? you certainly do get stuck in.... is that an easy repair or not?

[danbmx_69]

Originally Posted by 75tourerSE

Oh my.... how do you think they did that Dan? you certainly do get stuck in.... is that an easy repair or not?

I don't really have a clue how someone has managed this, it is an easy fix as I have a new seal, just nees to get some silicone gasket sealant to put it on with

[danbmx_69]

could any one tell me the torque setting for the flywheel for when i put it back on?