|
|
|
|
|
|
||
|
|
||
20th January 2020, 14:36
|
#7 |
|
Newbie
Rover75 Join Date: Dec 2016
Location: Camberley
Posts: 9
Thanks: 0
Thanked 1 Time in 1 Post
|
Camberley
Thanks Macaffee2.
On the your diagram, just below the top right corner where it cuts in, the material has pulled away from the screw/clip. There is faint evudenbce on the diagram showing its location. I had in mind to rebuild and re-inforce the card/plastic with some form of epoxy material. Also using a larger washer to strengthen that area |
|
|
|
|
Threaded Mode