FBH diagnostics

madmatt · 12th December 2019, 00:23

Hi all was wondering if someone could give me some help .I've been having some issues with my fbh . So I decided to investigate a little further and made a diagnostic loom similar to this one with the addition of a wire to pin 3.https://rover.ebay.com/rover/0/0/0?m...2F192411838077 along with a cable like this which I use for Toaf https://rover.ebay.com/rover/0/0/0?m...2F392399423116 however no matter what I seem to do I can't get the wabasto software to communicate with the fbh weather it be using the loom I've made directly attached to it or though the car using the obd port. Do you have any idea where I'm going wrong I've seen talk of using a 1ohm resistor but am unsure if this is my problem and if it is how to apply it .
Many thanks Matt

12th December 2019, 00:23	#1
madmatt Regular poster Connoisseur SE CDT Saloon Join Date: May 2013 Location: coventry Posts: 74 Thanks: 27 Thanked 0 Times in 0 Posts	FBH diagnostics Hi all was wondering if someone could give me some help .I've been having some issues with my fbh . So I decided to investigate a little further and made a diagnostic loom similar to this one with the addition of a wire to pin 3.https://rover.ebay.com/rover/0/0/0?m...2F192411838077 along with a cable like this which I use for Toaf https://rover.ebay.com/rover/0/0/0?m...2F392399423116 however no matter what I seem to do I can't get the wabasto software to communicate with the fbh weather it be using the loom I've made directly attached to it or though the car using the obd port. Do you have any idea where I'm going wrong I've seen talk of using a 1ohm resistor but am unsure if this is my problem and if it is how to apply it . Many thanks Matt