|
||
|
|
20th May 2007, 13:13 | #1 |
This is my second home
Jaguar XE Join Date: Nov 2006
Location: Coventry
Posts: 4,321
Thanks: 56
Thanked 59 Times in 55 Posts
|
Ultrasonics ?
Afternoon gents,
Doing a bit of digging about to find out if ultrasonics can be retrofitted to the 75/ZT. Fitted to the top of the o/s B post when in the vehicle. One question I need to know is if your 75/ZT has no sensor fitted can somebody carefully lower their headlining to see if the multiplug is there. I have a sensor just need to know if the loom is there prior to cutting holes in the material. Muchos gracias peeps. |
20th May 2007, 13:30 | #2 |
This is my second home
MG6 TL Join Date: Nov 2006
Location: Tarn
Posts: 5,269
Thanks: 2
Thanked 46 Times in 37 Posts
|
Just had a quick look by pulling the plastic jobby away that the seat belt runs through, and I couldn't see anything.
|
20th May 2007, 13:55 | #3 |
This is my second home
Jaguar XE Join Date: Nov 2006
Location: Coventry
Posts: 4,321
Thanks: 56
Thanked 59 Times in 55 Posts
|
Think it will run along the roof Mr Tatts.
|
20th May 2007, 15:37 | #4 |
This is my second home
Rover 75 V8 Join Date: Oct 2006
Posts: 3,448
Thanks: 0
Thanked 206 Times in 32 Posts
|
iirc it was never part of the standard roof loom - as with the sunroof power lead and phone mic lead they were often add on's. Most likely not there Lates
hth Mike
__________________
Mike [SIGPIC][/SIGPIC] |
21st May 2007, 17:57 | #5 |
Loves to post
Rover 75 Tourer Join Date: Nov 2006
Location: Scotland
Posts: 412
Thanks: 0
Thanked 1 Time in 1 Post
|
Haynes' circuit diagram shows the U/S module connected to pins a15,a31 on the BCU, if you're able to check that. Also shows earth lead to base of RH A pillar.
|
21st May 2007, 19:53 | #6 |
This is my second home
Jaguar XE Join Date: Nov 2006
Location: Coventry
Posts: 4,321
Thanks: 56
Thanked 59 Times in 55 Posts
|
Ah ha maybe getting somewhere, where is keith when you need an electrickery expert
|
|
|