Heated seat switch wiring
I'm about to fit heated seats to my Mk1 ZT and found the wiring loom for the switches very easily. After removing the switch fascia plate the seat switch connectors were bundled together wrapped in sticky tape together with the connector for the rear blind switch and all three were lodged in the slot where the blind switch usually goes. The seat looms were even helpfully labelled as to which was left and right! They are together quite a substantial bit of wiring so if you can't see them, the likelihood is that they're not there. Do you have cruise control? I do and have been told that if the factory was fitting wiring for one item in the lower switch panel then they fitted all of them, even though only one was being used.
|