In another forum topic (
https://www.mg-rover.org/threads/t4-testbook.5362/ ) I found an "installation guide" one part of it says:
Quote:
network card configured for
TCP/IP protocol alone with a specific IP address of 192.168.1.2, but
no subnet address and with Workgroup T4 and computer name T4.
|
assuming it is the same for LR,
1. I am able to adjust the TCP/IP protocol to 192.168.1.2 BUT I need to fill in a subnet address otherwise it will not accept. Is this a step I have to do or will the software adjust this for me?
2."Workgroup T4 ? Is that something I have to adjust?
3. Compter name T4, Done!