Good Morning all.
My Diesel still giving problems cutting out when coming off the gas and engine running on briefly when switched off.
Thinking that perhaps I had done a shoddy job changing the O rings, I ordered another set and have just fitted them. When I first restarted the engine, all seemed fine, switched off and engine stopped as it should. Went for a 20minute run and all seemed ok until as I was parking the engine cut out again. Restarted no problem but when I switched off, the engine ran on again.
There is no one close with a T4, just an ex-Rover garage that is very pricey. Is it possible that the sensor at the end of the fuel rail is dodgy or the complete regulator?
Thanks.
Last edited by polinsteve; 5th April 2017 at 12:10..
|