Quote:
Originally Posted by T16
I bought this:-
https://www.ebay.co.uk/itm/BMW-3-E36...8AAOSwZoZacvdP
However I just went to use it, and the part of the tool thats meant to push the joint is a nice close fit over the rubber gaitor, but then its 3mm short of butting up against the outer casing of the joint.
What is going on, Ive never seen a tool which relies on pushing the center of a rose joint before. This will damage it surely?
Just waiting for tablet to charge for a pic.
Really annoying. It is the right kit for the right balljoint!
|
No it's not the right kit, it's a Vectra B/Saab tool
It's what I used, however I did machine up a proper cup
I would suggest once you remove the old bush, knock out the centre and use the outer part as a spacer