Next up I had to prime everything else in the same QDR.
I even keyed and primed all the new parts as they will be getting the same top coat to give them the same protection for many years.
The front suspension parts.
You will notice there is a hub missing. As I stated previously my spare was knackered so I am hoping that when I remove mine from the car it is good.
Additionally I didn't keep the anti roll bar brackets from the car i broke so hopefully mine are ok
New backing plates and shocks also primed.
IMG_20191011_160616 by
Jon Christie, on Flickr
The rear suspension parts
again missing atop mount and the new upper arms, shocks, tie bars and mounts primed ready for top coat.
IMG_20191011_160225 by
Jon Christie, on Flickr
Additionally all the rubber and plastic used on these parts cleaned and restored ready for fitting
IMG_20191012_160158 by
Jon Christie, on Flickr
And finally the subframe bolts back from the platers
IMG_20190914_200745 by
Jon Christie, on Flickr
So now in the middle of top coating everything and ordering new fastenings for all the parts.
I need to get the lowering springs cleaned off and powder coated but will do that when I remove my roll bars from my car so they all get done at the same time.
__________________
Jon C
Living the dream
MK IV VVTI Tiptronic TT Toyota Supra MG ZT 190+
BornTuesday, 10th July 2001 @ 09:01:10
259th ZT to run off the production line, out of 18,894
252nd ZT 190 + to be made out of 4,023
101st ZT in Solar Red (code: CEU) to be made out of 1,888