Quote:
Originally Posted by Schotten
Hoped this would solve the no loom problem (been wanting to add cruise to my 2.0 diesel Connie). Followed the instructions (excellent work guys) and two days of work later......nothing!! Cc switch illuminated so looks good, press it and green tell tale comes on, but that's it. Tried pressing Res and Set. Nada no little orange light on IPK. Any ideas? t4. Interestingly when I put the IPK back in the brake pad low warning has come on! Checked pads/disks and sensor, all ok . Oh dear says my wife!!! Help!
|
Sorry to hear it doesn't work.
Did you take extra caution with the connections/soldering and made sure that every pin went where it had to go so you can rule these out?
Silly to even ask (I assume you followed the wire colours and pin numbers), but did you use the correct plug for the cruise interface plug? I added a picture of the plug from a petrol variant which is a little different.
Where did you splice the can-bus wires (yellows) to?
__________________
MODS: Front fog lamps, FBH timer switch, FBH OBD, boot and arm rest power sockets, cruise control, Powerflex lower arm bushes, illuminated vanity mirrors, high-line IPK, Symphony stereo + SLE, 160 remap, Revotec fan, 12N+12S, auto-dimming rear view mirror, rain sensor, volumetric alarm sensor, PDC, powerfolds, sports leather memory seats, passenger anti-trap sensor
TO DO: Tilt sensor, low coolant sensor, FBH GSM remote control, heated washer jets, front parking sensors
|