Quote:
Originally Posted by morgymoo
So been today.There is no orange clip on the filter but everything looks as should be no separation. Put direct power to pump (on a noisy road) but did not hear pump running. I looked at the rev counter while cranking it only moves about 5mm not even to first mark and does not move or jump about until the key is released and then it goes back down about 5mm to stop. could this be the crank sensor not giving a signal to pump relay?.If so is the sensor the one at the front in the bell housing?
thanks for your help
|
As the car is a 2003 then I would expect the later type filter, or the one that the clip was produced for.
OK you put power directly to the pump and didn't hear anything but did you ensure the black cable or pin was earthed? And you lifted the rear seat and removed the normal plug on the fuel filter to do this?
Sorry I've no idea where to find the crank sensor on a 1.8 (only have V6s), use the search bar. But as the needle does move I would think the sensor is fine.
Regards