Quote:
Originally Posted by morgymoo
Ok thanks for that. Have had delphi diagnostics on there, no crank sensor faults, did have a fuel relay fault, after swapping relay cleared the fault. Fault has not come back since. (no fault codes).I will check if rev counter moves whilst cranking tomorrow.
Thanks
|
So been today.There is no orange clip on the filter but everything looks as should be no separation. Put direct power to pump (on a noisy road) but did not hear pump running. I looked at the rev counter while cranking it only moves about 5mm not even to first mark and does not move or jump about until the key is released and then it goes back down about 5mm to stop. could this be the crank sensor not giving a signal to pump relay?.If so is the sensor the one at the front in the bell housing?
thanks for your help