Quote:
Originally Posted by morgymoo
Hi all, car wont start, cranking over fine, no sound from fuel pump with ignition on. After reading several posts. I have swapped relay r3 and checked fuse 28 all good. I have no power at the purple and white wire that feeds the pump. If i were to remove the relay and put 12v power to the purple and white that feeds the pump the car should start (yes ?). My question is if this works which wire to the relay should have ignition feed so that i can run a new feed to that
Thanks for any advice in advance
|
If you were to put power directly on the purple/white and the black is earthed then yes it should run the pump.
I understand that if the crankshaft sensor is defective then the fuel relay will not energise - is yours working, any fault codes, observe while cranking if the rev needle moves.
Regards