Quote:
Originally Posted by stocktake
The plugs go to the sensors in the exhaust one of them is quite close to the vis motors at the back of the engine.
Just to make sure you have the correct plugs fitted to the Vis motors you should have the following colours on the plug.
Power:
1. Orange/Yellow
2. Black
3. Blue/Yellow
4. Blue/Pink
Balance:
1.Grey/Black
2. Blue/Orange
3. Black
4. Blue/Yellow
|
SO... the VIS plug and the lambda sensor plug were swapped.(I had a o2 sensor error code but I thought this would go away after i drive it around since the car hasn't moved since 2014)
i feel so dumb now
) but i would never thought that the o2 sensor could have the same plug as any other plug on the engine.
NOW.. the power vis does this: With the cam of the gear between the microswitches if I plug in the cable the gear rotates and when it hits the microswitch it stops. But when I test it with the diagnose it doesen't rotate towards the other microswitch.. the balance motor does.