Quote:
Originally Posted by T-Cut
........ With the old bulbs back in place, I now decided to use the sticky mastic to reattach the lamp unit to the lid. The mastic comes in quarter-inch wide rolls with a peel-off backing. Two strips over the PBC would protect it from moisture and hold the unit in place. Here's the 'Flexistrip' mastic going on.
EDIT: If you want to use this sticking method rather than a double-sided foam strip, you need Butyl strip/tape available in various widths from eBay.
Image 18
|
TC - is there a reason you didn't use wider 'Flexistrip' instead of two 1/4" strips?
I'm thinking of using this stuff (12mm wide, 2.5mm thick) -
https://www.ebay.co.uk/itm/BUTYL-GLA...-/222432763538
Or even this stuff (20mm wide, 1.5mm thick) -
eBay link - too wide perhaps (and/or too thin perhaps)?
I'm not sure whether you covered the PCB with the Flexistrip or cut round it - can't quite see from pic 18 'cos the backing paper is still on.