Quote:
Originally Posted by Typhoon190
I would check the inlet manifold gaskets.
I've had a number of attempts at overcoming a similar issue.
http://www.the75andztclub.co.uk/foru...+gasket&page=2
My last attempt at replacing these has been the most succesfull, thanks to advice from Simon (SD1too) in terms of the tightening sequence.
It lasted around 3 months, but has now started leaking again, albeit at a much lesser rate than previously.
To me it's clear they are only just capable of doing the job.
|
Thanks for the info, very handy to have. however I have not touched the inlet manifolds or thermostat or water pump since I started this thread so I don't think this applies to me as it would not explain the pressure build up I get in the expansion tank (over 19 PSI measured)