Quote:
Originally Posted by jymix
Hi all,
Still in Safe Mode:
to align the second pulley, I had the following choices:
1 - turn the pulley in the direction of clockwise (135 °) or
2 - Turn the pulley in the opposite direction clockwise (225 °)
I made the choice "1". Is this the right choice?
Watching the video replacement belts that Workaholic recommended me. Just before tightening the bolts, the technician turns the camshaft approximately 45 degrees in the opposite direction clockwise using tool 18G 1747/4 and a key.
I have to do that to? (Whith or without the tools)?
.......
Thank you again for your help
Good Sunday to all
|
I think I need to view photos because I did not understand everything you say.
I try to be accurate for me to understand despite my bad English.
I've aligned the pulleys then I turned the engine manually and started the engine.
Your advice is correct. I wouldn't have had to start the engine without doing what you say. I did not everything. In fact I'm not a mechanic. This is why I need to know if what I've done is right. Forgive me if the answers to my questions are obvious to you. But this isn't the case for me.
In addition, I'm all alone in a small village a bit special and nobody wants to help me.
If you could answer my questions, then it would allow me to apply your instructions
Your conclusion is probably just as two months ago, I forced several times to start the engine.
I'll take pictures of the small belt the most damaged.
Thank you Kaiser