Hi all,
Still in Safe Mode:
to align the second pulley, I had the following choices:
1 - turn the pulley in the direction of clockwise (135 °) or
2 - Turn the pulley in the opposite direction clockwise (225 °)
I made the choice "1". Is this the right choice?
Then I prepared and installed the belt by tightening the bolts
I tried to start the engine but it doesn't start.
@ Workaholic, do I position my pulleys like your picture to replace your belts?
because in save mode, the hollow part of the mark of the right pulley is inside then it is outside in your pic. Does the pic was taken in Safe Mode?
Watching the video replacement belts that Workaholic recommended me. Just before tightening the bolts, the technician turns the camshaft approximately 45 degrees in the opposite direction clockwise using tool 18G 1747/4 and a key.
How to get there without any tools or enough room to put something could turn to? At this point there are pipes of the cooling circuit, the level pipe oil and the the hydraulic system tank. And camshaft, I have a new but how should I proceed to put in place?
I ask myself these questions since 3am
Thank you again for your help
Good Sunday to all