Quote:
Originally Posted by rab60bit
Your Post#1 mentioned the 'box' (it's the position sensor sender) was not fixed to the body mounting bracket - "...two holes". I can't quite tell from the image but in all other respects everything appears to be as it should - correct arm orientation, arm 'unbent' and clip to lower suspension arm intact. If both arm ball joints are free to work (I'd remove the plastic arm - a 5 minute job once you have clear access - and clean/grease it just to be sure) then the only problem is to re-fix the 'box' to the body bracket (I'm guessing - by a couple of M3/4 x 35 screws) otherwise the whole assembly will just waggle about.
I've noticed
|
As you can see it is sort of held by a cable clip which I've replaced by wrapping a choice length of top quality green garden wire - no expense spared here. The arm is covered with dear old Copaslip.
Thanks.