Quote:
Quote:
Originally Posted by Blink
You mean straighten existing bend A and re-bend the hanger at (say) point B?
|
NB. Just to illustrate the problem here's a pic of the closest point between the RR323V pipe and the ARB. This is with the back box lowered enough to allow a gap of about 15mm (I can just about get my index finger through).
Pic taken with camera beneath the middle of the spare wheel well looking forward to the left upper arm.
|
Hi Simon
Yes that was what I was thinking it could work for you, but also make sure as above it is lined up correctly, mine was touching a little until I twisted the back box a little then clamped it tight.