Quote:
Originally Posted by Best_of_British
Just dug this post out as I remember a pic of a bearing puller David Lawrence used to seperate joint, unfortunatly PhotoBucket strikes again.
Ive done this twice before and both times dropping car did not budge it and I had to get it on a 4 post with drift chisel and huge hammer. I would like to avoid this and do it on the drive, has anyone got a link to a bearing puller that may work.
Sent from my GT-I9195 using Tapatalk
|
This is almost the same as the one I use;
https://www.amazon.co.uk/TecTake-BEA...ller+kit&psc=1
If the taper joint is well seized into the subframe, then you will need to use quite a lot of force on the puller, and one of mine has got slightly bent undoing a stubborn wishbone, but this piece of kit has always shifted them in my hands.
Pete