[jonc3725]

Wrote an update up last night but lost it for some reason. not sure why but it was late

Anyway as some of you are aware I have started work on the car. My plan is to go from back to front starting in the boot and at the back of the car working forward then go underneath.

So starting at the back:-

Boot and rear before I have started



and with everything removed





The rear end as I picked the car up



and now with bumper removed



The boot seal needed replacing, The drivers side boot vent was perished so I replaced it and sealed both vents for future posterity. The boot was cleaned out to a nice shiny finish





Cleaned out



and with new seal fitted and a pre project tool kt



Next was to fit this little lot for reversing sensors. I decided to use the oem system.



I was lucky enough to have the original loom fitted and the connection was tucked away under the rear quarter



next was to fit out the mounting plate, control module and internal loom which goes out through the rear bulkhead in the centre of the boot















Next job was to cut the holes in the bumper, spray the sensors in solar red and fit along with the external loom. Will update later as I have to go out