Quote:
Originally Posted by cabbers
The connector is just sitting there unconnected to anything Jake as the other end of the connector which i believe should be on my car loom is no were to be found, we have found were there are 2 wires exactly the same as 2 of wires on the connector but we cant find any wires of the same colour as the other 2 - hence why in post 1 i asked what each wire was for.
|
I'd put money (not that I have any) on that being the reason. You'll find that most likely that the nav part of the system wouldn't work as that connector is looking for the abs sensor feed (green/grey) isn't connected. I'm pretty sure there is also a K-Bus wire in that connector as well which communicates with the car (trip computer information shared from the IPK for a start.)
When I was in the UK last week I had made an adapter for Dominics V8 and as a result there were some wire rounds where you have to wire the highline loom directly into the car harness. Depending on the age of loom there will be other wires in there that if not fed will cause the system not to work.
Depending on your urgency on getting this all working 100% I am flying back for the next nano and could set it all up then for you as I did Scouses from scratch in a weekend.
More than happy to answer any questions on the e-mail Craig if I can help. Alternatively you can call me.
Jake