heated seat wiring
hi
I'm fitting replacement heated,electric leather seats to my 55 plate ZTT 190 + my question is that although the wiring looms are already in place for the seats to plug into I cant seem to find the plugs for the heated seat swiches behind the facia panel. I just presumed that if the seat looms were already there then the heated seat switch plugs would be present too. any help greatly appreciated thanks:bowdown: |
Remove the air con panel and they will probably be wrapped up behind it,
Mick |
done that pal cant see owt
|
Heated seat switch wiring
I'm about to fit heated seats to my Mk1 ZT and found the wiring loom for the switches very easily. After removing the switch fascia plate the seat switch connectors were bundled together wrapped in sticky tape together with the connector for the rear blind switch and all three were lodged in the slot where the blind switch usually goes. The seat looms were even helpfully labelled as to which was left and right! They are together quite a substantial bit of wiring so if you can't see them, the likelihood is that they're not there. Do you have cruise control? I do and have been told that if the factory was fitting wiring for one item in the lower switch panel then they fitted all of them, even though only one was being used.
|
hi
no cruise fitted,going to have another good look but don't think its there,got a/c panel and radio out and cant see nowt,just my luck |
I have on the odd occasion found them up behind where the stereo is fitted whilst dismantling,
Mick |
Another hiding place for these connectors is - behind the ash tray area inside the console, you will be looking for a grey coloured foam end with a few cables entering it. You may need to unclip the ashtray/cupholder section to enable a good search for them.
|
All times are GMT. The time now is 06:18. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd