electric drivers seat issue
None of the electric controls on my drivers seat are working. It's the seat with memory. The fuses are fine. The passenger seat controls are working. I can't see any damaged wiring under the seat. Any suggestions what to do next? Are the driver and passenger seats controlled by a single ecu? If doing an ecu reset, how long does the battery need to be disconnected for?
Thanks folks for any help. |
Quote:
I seem to recall Rimmers have new ones. A scrap yard may have ones in a seat that works macafee2 |
Had this a few times with my rover I have disconnected the battery for 30 mins then put back on and all been ok again worth a try first before you dig deeper or shell out money
Regards paul |
Disconnected battery for an hour and then reconnected. Still no joy. Any more suggestions? What is the black box under the seat?
|
I wonder if these seats use the same motor that is in the sunroof? This is a very common motor that is used in lots of cars, BMW's included. Good luck with your investigations - my donor car has a passenger electric seat that just goes clonk when you push the fore/aft button but tilt works fine :shrug:
|
Can any one confirm if there are 2 motors in the driver's seat? Also is there a relay for the driver's seat?
|
Quote:
back and forward base tilt back tilt |
Thanks for that. So if none of the controls is working it would indicate that no power is getting to all 3 motors?
|
Quote:
|
I'm kind of beginning to think it's the memory seat ECU. Can anybody confirm if the early ECUs can be used in the facelift cars?
My ECU just states that it is a 'seat memory module'. The early ones are 'seat mirror and column' module. |
All times are GMT. The time now is 15:42. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd