Best Way To Fix Driver’s Door Panel
2/75. 54 plate Drivers door panel torn off top right retaining screw.
What is the best way to repair or would it be easier to get a substitute top half panel. |
https://rimmerbros.com/ItemImages/Large/GRID001903.jpg
Which part of the door did you mean? The interior? or exterior trim? Also probably best to remove your address from the subject bar for the post. |
Hi M6dly.
Thanks for the diagram. Panel 13 is the problem. There is a small retaining screw and pathetic washer holding that corner to the door and the fabric of the panel has torn from the screw mounting and is now waving in the breeze. Tried removing address by editing to no avail. |
Quote:
|
Thanks J1MBO. Moderated.:}
|
I thought 13 was just some foam or polystyrene?
see item 16 here https://rimmerbros.com/Item--i-GRID001902 macafee2 |
Camberley
Thanks Macaffee2.
On the your diagram, just below the top right corner where it cuts in, the material has pulled away from the screw/clip. There is faint evudenbce on the diagram showing its location. I had in mind to rebuild and re-inforce the card/plastic with some form of epoxy material. Also using a larger washer to strengthen that area |
The "fir tree" clips often break when trying to remove but are the best fixings to keep the door card in place.
https://i.imgur.com/i53D6EF.jpg?1 |
Macaffee2
Thanks.
I think that will solve the problem but that top right area is rather weak. I'll give it a try.:} |
Quote:
if on my diagram it is item 1 you are having trouble with that's a different beast :) macafee2 |
All times are GMT. The time now is 13:31. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd