Looking a bit past penny washers
My rear Exhaust Shield .. been hanging over the pipe a few days ?
all the 4 points are shot .. http://oi67.tinypic.com/2819o1.jpg http://oi65.tinypic.com/2n7lctx.jpg some fancy plates to knock up ;) Seems electrolytically dissimilar metals corrosion doesn't exist in MGR design world :duh: C |
How about aluminium strip shaped into a curve to match the shield and held in place by the original shield bolts?
|
:wot: :iagree: :wot: Yep did that with mine - stainless plate though - only because that's what was in the leftovers bin at work. :D
|
I nicked some lovely large size stainless washers out of my sons “bike bits box” :eek:. They did the job but yours are beyond that.
Light aluminium plates should do the job. |
if in doubt over engineer it ... got lots of bits of stainless, so.
http://oi68.tinypic.com/2lwq047.jpg Done for speed as its cold out ..and for function rather than looks :o.. Didn't even bother to clean up the JC5A front end clamped by big stainless plates as well ;).. Won't fail in my lifetime now :shrug: ;) nor corrode again ! Fits perfectly C. |
I've kept some old heat shields from a ZT I broke if you want a square of decent material to make up a bit where the corrosion has taken hold justvPM me. I kept it for this reason.:D
|
All times are GMT. The time now is 17:48. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd