How to replace bushes on 3 speed fan
Hi,
As above is there a how to, with pictures....on how to replace the bushes on the 3 speed fan? Thanks in advance! |
Hi Joe,
If you search under the user name Arctic you will find lots of helpful pictures which tell the story. By the way, they're called brushes because they sweep around the commutator. A bush is a simple type of bearing which, of course, is entirely different. Buy them from Engineering Carbon Products Ltd. in the U.K. because these are based upon the OEM component and were developed with the assistance of club member Greeners and me! You'll need to buy a set of four and unfortunately the cost of international postage is rather high. However, you'll only need to do this job once. The alternative is e-bay but there have been reports that these only last five minutes so this option is not recommended. Simon |
Quote:
Regards |
Quote:
|
Quote:
One could infer from this that the brushes move. |
Quote:
Relativistically, that's correct. |
Quote:
Oh dear. Ok. moving on. |
Thank you all for your replies, yes Simon i have already purchased the "brushes" :duh: from ECP UK, expensive...but no real alternative over here, there are just no second hand fans that i can find to cannabalise.
|
Quote:
From any point on the armature, the brushes appear to rotate around, it so the answer to your question was yes. That's what I meant by relativistically. (Blame Einstein.) TC |
Quote:
|
All times are GMT. The time now is 02:35. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd