The 75 and ZT Owners Club Forums

The 75 and ZT Owners Club Forums (https://www.the75andztclub.co.uk/forum/index.php)
-   The 75 and ZT Owners Club General Forum (https://www.the75andztclub.co.uk/forum/forumdisplay.php?f=9)
-   -   Airbag light on and water damage. (https://www.the75andztclub.co.uk/forum/showthread.php?t=318792)

skinnyL 21st April 2022 14:57

Airbag light on and water damage.
 
Can anyone advise how to remove the centre consul, manual gearknob plus rear seat, also the radio etc I have removed the eyebrow but am stuck as there are just 2 small slots each end of the radio and am not sure how to proceed from now.

This will enable me to remove the carpet as it is soaking.

I have done the sunroof drain modifications and removed the seats of my LHD car here in Spain and as I am on holiday I need to get this done quickish but am stuckon the carpet removal. pLUS MY BACK AND LEGS HURT NOW AFTER ALL THE BENDING AND TWISTING DOING THE MODIFICATIONS LOL.

Any help greatly appreciated.

JIm

stevestrat 21st April 2022 15:16

The slots either side of the radio are for thin metal tools that slide in and release the spring clips holding the radio in. Although I've never tried it apparently you can get away with a couple of hacksaw blades, remove the pin at the end of the blade first obviously.

skinnyL 21st April 2022 15:48

Thanks for that Steve, might also try a knife blade.

Will that enable the consul surround to come away then do you think. I have taken out the two screws in the lower middle.

suzublu 21st April 2022 15:59

See if this helps https://www.the75andztclub.co.uk/for...ad.php?t=55332
Gear knob just pull up, mind your nose
Rear seat, lift up the base, pull towards the front.
There's a couple of bolts behind the rear ashtray/cubby too

skinnyL 21st April 2022 16:14

It is a manual. I know mine at home is an auto and that was just pull up and mind you nose, so is the manual the same then?

Thanks for info.

skinnyL 21st April 2022 16:18

Quote:

Originally Posted by stevestrat (Post 2929324)
The slots either side of the radio are for thin metal tools that slide in and release the spring clips holding the radio in. Although I've never tried it apparently you can get away with a couple of hacksaw blades, remove the pin at the end of the blade first obviously.

Hi Steve,

Tried a junior hacksaw blade, with the pin removed! Goes right in, but no movement of radio and does not appear to move anything.

Once the radio is removed does that allow you to access screws or something so that that part of the consul is released?

suzublu 21st April 2022 16:20

Quote:

Originally Posted by skinnyL (Post 2929337)
It is a manual. I know mine at home is an auto and that was just pull up and mind you nose, so is the manual the same then?

Thanks for info.

Manual is pull off, maybe a little twist as well
Quote:

Originally Posted by skinnyL (Post 2929339)
Hi Steve,

Tried a junior hacksaw blade, with the pin removed! Goes right in, but no movement of radio and does not appear to move anything.

Once the radio is removed does that allow you to access screws or something so that that part of the consul is released?

The radio is secured by 2 screws top corners, then ease out:cool:

stevestrat 21st April 2022 16:26

Quote:

Originally Posted by skinnyL (Post 2929331)
Will that enable the consul surround to come away then do you think. I have taken out the two screws in the lower middle.

Its not a job I've done before so couldn't say. There is useful info in this thread https://the75andztclub.co.uk/forum/s...d.php?t=182781.

skinnyL 21st April 2022 16:55

I have managed to remove the gearnob,pull up but mind your nose! Thank you.

I still cannot get the radio to move using a thin blade in the 2 slots, I also have a cassette linked, but no movement! any other ideas? I think once the radio and heater assy is removed the consul should come out.

suzublu 21st April 2022 17:06

Quote:

Originally Posted by skinnyL (Post 2929346)
I have managed to remove the gearnob,pull up but mind your nose! Thank you.

I still cannot get the radio to move using a thin blade in the 2 slots, I also have a cassette linked, but no movement! any other ideas? I think once the radio and heater assy is removed the consul should come out.

Have you removed the 2 screws above the radio?
https://www.the75andztclub.co.uk/for...2fd8b7606a.jpg


All times are GMT. The time now is 15:08.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd