My MG ZT Flat cap wearing Automobile
 

Thought i would stick a few on of my ZT

picked it up end of September from ebay for £700

oh and it was a old boys car done less than 5k in last 3 years :)

had a recent new clutch fitted and timing belt costing £900

113k on the clock but with the above spent on her i thought it was a decent price

only worry was the mot ran out in January :eek:

glad to say she went in Friday and failed on a bulb not being lined up (my fault for fitting new bulbs and not being able to fit the clip back on)
But very happy with the overall outcome

Gave it a full service and new brakes

Andy Willi came and did the alt belt and 6 spark plugs:D
new number plates

running sweet at min

http://i778.photobucket.com/albums/y...ps039d10c3.jpg
i have tinted the rear lights a little but not sure yet
http://i778.photobucket.com/albums/y...ps3375e953.jpg

http://i778.photobucket.com/albums/y...ps09c07216.jpg

Tidy up of the engine bay
http://i778.photobucket.com/albums/y...ps6e1c9767.jpg

http://i778.photobucket.com/albums/y...ps38b331b6.jpg

These to go on

http://i778.photobucket.com/albums/y...ps250bd822.jpg

Very nice looking car.

Looks very good, presume the anthracite wheels are for your car and will enhance the look even more.

That's a gorgeous car. Love the colour.

That looks lovely, will look immense with the anthracite hairpins.

Very nice zt. i presume its zircon silver. got one the same colour i think the colour
looks great .on the zt .

Looks mighty fine especially with the rear tints. Post more pics once the new wheels are on. I'm about to fit the same induction kit do you get any excessive noise?

Thanks :D

Yes Zircon silver

and the alloys will be fitted after winter

i also have a set of Gridspokes i might refurb
http://i778.photobucket.com/albums/y...ps950911ee.jpg

a lot more induction roar when you plant the foot down

What about mpg .does the induction kit youve used .badly effect it
has i was thinkin about doing the same. regs tonk

How cool is that! If that was sporting a '63' plate then I wouldn't question it, if I didn't know better. :D