75er |
20th April 2019 00:57 |
BM54 housing
I wonder what other members have done when then swapped their Rover tuners for BM54 units in relation to the housing the tuner sits in? The BM54 tuner is slightly bigger than the Rover unit and on the tourer at least the BM54 doesn't fit into the original Rover housing in the boot. I guess its the same for the saloon. I know there is a housing part from BMW which fits the car and also the BM54 unit, but this part is almost impossible to find. The only option would seem to be to cut the original Rover housing with an angle grinder? Is that what people have done? If so where did you make the cut, on the long or short section on the housing? It would be good if we could find someone to make a housing which fits the bolt holes in the car and which fitted the BM54 unit. I guess quite a few members who would buy one if they were available.
|