Door card removal
 

When removing door cards, ignore Haynes, they make it difficult!
Simply unscrew the pull handle surround, unclip all around the edges, ensuring the clips all stay out of their holes, then nudge the panel upwards (from the bottom edge) effectively sliding the panel vertically upwards. this disengages the steel centre clips from the door. To replace the panel, remove the steel clip from it and replace in the door, on its bracket. The panel can then be nudged back into position, and the clips re-engaged by tapping the panel back into place, using a flat hand. make sure the handle is correctly placed, and that the wire link has not been disconnected. Job done, time taken to remove and replace 5 mins.
This post is for those who don't know the trick!!!

I had to do this today for a rear door and I'd recommend putting some duck tape over the back of the small speaker as it is only lightly clipped in. Otherwise when you thump the door card, at the top, to locate it, the speaker will keep falling out.