Stock clearance - 75 / ZT bits and pieces
 

Hello all, thought I'd chuck this in General as I know you all love a bargain!
We've managed to nab even more interesting stock from SAIC - it's due to land with us nearer Christmas, but we need to make room.
Not even room for Santa's milk and mince pie at the moment! :D

We've put one some clearance pricing for common bits and pieces here:

Headlamp Washer Jets 75 / ZT (Mk2) £19.99 per pair
75 / ZT Front Lower Arm Bushes (Genuine) £39.99 per pair
45 / 75 / ZS / ZT Side Repeaters £1.99 each
Full KV6 Engine Bearing Set £99.99 per set
BERU KV6 Coil Packs (late style) £69.99 per set
45 / ZS Rear Compensator Arms £44.99 each (NLA)
75 / ZT Inner Tie Rods £19.99 each
75 / ZT Jacking Point Pads £7.49 each
75 / ZT Scuttle Panel Clips £7.99 per set
75 / ZT MG7 Climate Control Unit £94.99 each
75 / ZT AP Clutch Master Cylinders £44.99 each
75 / ZT Complete Rear Brake Backplates £99.99 per pair
KV6 VIS Motors £84.99 per pair

Click here to view and order.

Thanks all! Happy motoring as ever :)

We've added some more goodies at discounted prices here:
https://www.dmgrs.co.uk/collections/bargain-corner

Don't forget to use FORUM5 for 5% off, too!

Is the lamp ass the uprated board? I tried getting mine to pieces to put just a board in and thought I was going to snap it so abandoned it! Also not sure what you mean by lip spoiler. Would it fit mine as it has a plinth and the large boomerang? Thank you.

I just bought an NTN/SNR rear wheel bearing kit, currently being shipped from Germany...for less than your discounted price. I believe it is of original spec. for my car, or very similar. Your offering looks the same, but is more expensive and doesn't include the hub nut either...

What a pity your prices preclude you from being the goto supplier...it would have been nice to support you in the Club.

We'll take that on board, cheers :)
The 'modern' SNR bearings are built a bit different to ours - can't say if it's for better or worse, but the strength we sell these on is that they're original Longbridge parts.

It will be interesting to see what you receive, as I purchased a 'genuine' SNR bearing, all packaged in SNR branded packaging. The bearing inside was FAG, with a separate reluctor ring. Same story with new X-Part stock.