rover 75 headlamp adjustment

david2000 · 3rd May 2023, 21:13

hi to all
the headlamp on the drivers side is low and needs to be adjusted now there are 2 adjusters 1 near the wing and the other is on the left which one do i adjust to change the horizontal
david

xsport · 4th May 2023, 14:51

vertical up/down adjustment is at the top centre- ish . sideways/ horizontal adjustment is on the outer most side nearest to the wing. They dont usually go that far out individually unless the adjuster has become detatched inside the lamp unit . sometimes they can pop out if they are near full extention but usually after over extention due to over adjustment. If thats the case then headlight removal for re attatchment can be done on the car but best removed.You dont say how far out the beam alignment is but, if its only a little you should be able to adjust it up against a wall , but mark out first and adjust bit by bit .. slowly.

3rd May 2023, 21:13	#1
david2000 Loves to post Rover 75 Tourer Join Date: Dec 2007 Location: Ammanford Posts: 496 Thanks: 248 Thanked 29 Times in 24 Posts	rover 75 headlamp adjustment hi to all the headlamp on the drivers side is low and needs to be adjusted now there are 2 adjusters 1 near the wing and the other is on the left which one do i adjust to change the horizontal david

4th May 2023, 14:51	#2
xsport Posted a thing or two rover 75 club se Join Date: Apr 2011 Location: Leicester Posts: 1,760 Thanks: 358 Thanked 419 Times in 310 Posts	vertical up/down adjustment is at the top centre- ish . sideways/ horizontal adjustment is on the outer most side nearest to the wing. They dont usually go that far out individually unless the adjuster has become detatched inside the lamp unit . sometimes they can pop out if they are near full extention but usually after over extention due to over adjustment. If thats the case then headlight removal for re attatchment can be done on the car but best removed.You dont say how far out the beam alignment is but, if its only a little you should be able to adjust it up against a wall , but mark out first and adjust bit by bit .. slowly.